357th FG Profile
Col. Irwin Dregne, last Commander of the 357th FG. 5 Victories in the air.
Col. Irwin H. Dregne’s P-51D Mustang “Bobby Jeanne / Ah Fung Goo”
Winter 1944 / 45
Modeler Tips:
Side View Notes:
A. Rear red band on propeller boss extends onto spinner to leading edge of blades when in neutral pitch. Determine width of yellow band by dividing remainder of spinner evenly.
B. “Bobby Jeanne” in black, all capitals rendered along lower strip panel seam.
C. 11 white swastikas on black circles- 3 in first column, 2 each in following 4 columns.
D. Pilot’s rank and name centered at level of seat, parallel to canopy rail.
E. Tail Number- black “411” on fin, “678” on yellow rudder.
F. “Ah Fung Goo” in black, all capitals, on starboard side lower strip panel.
Upper & Lower View Notes:
G. Glare shield is flat black and tapers away from upper cowl seam toward center of aircraft from forward bulkhead to propeller boss.
H. Width of checkers reduced on underside in order to fit evenly on the
narrow surfaces of the chin scoop area. I, J, K. Red, Green, Yellow navigation lights- circular and flush with wing panel.
L. Formation Lights- Red (Port) and Green (Starboard)
Overall Modeling Tips:
*Paint on the flat colored glare shield and rudder first- then mask them off and paint the remainder of the aircraft in natural aluminum color. Most metal colors will be marred or removed by masking materials and should therefore be applied last. Note that this aircraft did not wear any recognition stripes, after the New Year ’45 most Mustangs in the ETO adopted
a cleaner appearance by omitting theatre markings.
*There were no antenna wires or mirrors installed in this aircraft.
*After building several 357th A/C over the past 30 years, I recommend painting the nose area forward of the exhaust cutout yellow when the flat features are painted. Then when decal time comes, carefully cut away the yellow squares from the checkerboard decal and apply the remaining strip of red checkers to the nose. This method significantly reduces the potential for bubbles, and wrinkles plus it makes exact alignment of the decal easier.
*Prior to assembly, wash clear plastic parts with a mild glass cleaner and gently wipe dry. Then use a Q-Tip to evenly spread clear liquid floor wax (Future Brand seems to get the best results) on both inside & outside. Protect from dust and let dry for at least 2 hours. The wax fills in microscopic flaws and creates an even gloss that is clearer & shines brighter than the original plastic underneath.
Repli-Scale Decal Sheet 48-5057
Bullseye Model Aviation Decals – Courtesy of Scott Brown
BMA481009 1:48 Bulleye Model Aviation Decals – P-51D – Yoxford Boys #2
